Livestock Wound Relief Spray for Dehorning, Castration, Branding and
Accidental Wound Treatment

GRO Wound Relief and Repair is a livestock welfare spray designed for
use during common livestock management procedures including dehorning,
castration, branding and ear marking in cattle. This original
formulation  supports livestock welfare when treating wounds created during these livestock husbandry procedures.

The product is formulated from a special blend of natural oils derived
from plants, and is certified as an Allowed Input under the Australian
Certified Organic Standard, making it suitable for use in organic
livestock production systems. GRO wound relief and repair is also
approved for use in cattle destined for the Korean export market,
the USDA National Organic Program (NOP) and GAP certified markets.

For use in cattle wounds for the following procedures:

Dehorning and disbudding
Surgical castration procedures
Branding
Ear Marking
Minor accidental wounds

GRO Wound Relief and Repair

Each ingredient has been proven in clinical trials, and/or by
traditional means to provide one or more of the following health
benefits.

Pain Relief - Reduced Bleeding - Wound and Tissue Healing -
Anti-Inflammatory - Antiseptic - Burn Relief - Insect Repellent -
Antihistamine - Increased Immune Response.

Ensure that you read the product label before using the product.
Follow the instructions carefully. GRO Wound Relief and Repair is not
recommended to be used for any other purpose than that which is stated
on the product label.

Dosage Chart:

General Instructions:

Shake the product well before use. Adjust the size of the spray cone
to suit your requirements. The conical spray pattern should be wide
enough to cover the whole wound and the area immediately surrounding
the wound.

The spray cone is able to be adjusted by twisting the spray nozzle
either clockwise (wider cone) or counterclockwise (narrower cone).

Application:

For best results apply the product immediately after completing the
surgical procedure. The shorter the time between the wound being
created and the product being applied the better the level of relief
experienced by the animal.

When using a surgical procedure that results in significant bleeding,
the sooner the application of the product the greater the
effectiveness.

Dehorning and Disbudding Wounds:

Dehorn or disbud the horn as normal using either surgical technique or hot iron.

Apply the product by spraying the prescribed number of trigger
squeezes to each horn wound. The dose rate has been calculated to
ensure that the whole area of the wound is able to be effectively
covered by the product.

Hold the applicator nozzle close enough to the wounds to ensure that
the product covers the entire wound and the area surrounding it.

This will ensure that all exposed blood vessels and nerve endings are
treated, and maximum relief and protection is achieved.

Ensure that the entire wound is covered and that the majority of the product

is applied to the wound itself.

Do not touch the wound with the applicator or your hands during the
application process.

This is an oil-based formulation and should be expected to migrate to
some degree around the treated area, helping with coverage.

Surgical Castration Wounds

Fully castrate the animal as usual.

Immediately after the second testicle has been removed, apply the
prescribed number of squeezes of the application trigger directly to
the wounds at the bottom of the scrotum.

Hold the applicator nozzle close enough to the incision wounds to
ensure that the product impacts the wound area with some force. This
will assist in having some of the product enter the scrotum and
reaching the severed blood vessels and nerve endings.

Ensure that the entire wound is covered and that most of the product
is in the area of the wounds.

Do not touch the wound with the applicator or your hands during the
application process.

This is an oil-based formulation and should be expected to migrate to
some degree around the treated area, helping with coverage.

Branding Wounds:

Brand the animal as usual.

Apply the product immediately after the branding process is completed

so that the entire branded area is covered, including the area
immediately around the outside of the brand.

Due to the significant variations in size of branding wounds it may be
necessary to apply more sprays of the product to ensure
the wound is covered.

A minimum of 3 full sprays (4.5ml) should be applied to each brand.

In most cases a maximum of 5 full sprays (7.5ml) will be required to
treat the branding wound.

Ear Marking Wounds:

Earmark the animal as per the normal procedure.

Apply one trigger spray of the product over the wound ensuring to
cover the entire incision and the surrounding area.

The maximum volume of product required is 2 full trigger sprays,
however this amount is not always necessary for this procedure.

Accidental Wound Care:

The nature of accidental wounds can be infinitely varied, and the
product should not be used to replace the advice or treatment of a
Veterinarian.

Severe wounds that would ordinarily be referred to a veterinarian
should always be dealt with in this way.

For smaller, less serious scrapes and cuts, this product may provide
some relief to the wound, may assist with the reduction of bleeding
and could help to protect the wound from infection.

The minimum quantity to be applied to any wound is 4.5ml, three full
trigger squeezes of the applicator.

For wounds which cannot be fully covered by 4.5ml, apply more product,
however do not apply to run off.

Accidental wound treatment results may vary. Results will be dependent
on the time between the wound occurring, and the treatment being
applied, and the severity of the wound.

Storage and Shelf Life:

Store any unused product in a cool, dark, dry location in its original
container, away from direct sunlight.

Do not refrigerate the product during storage.

Wherever possible avoid removing the spray nozzle from the bottle as
this may allow the introduction of contaminants which could lead to
wound infections after application of the product.

Be very careful not to introduce any water to the container as this
may cause the product to become rancid, and unsafe.

For best results, do not decant the product from its original
container as this may lead to the introduction of contaminants.

If transferring a spray nozzle from one container to another, be very
careful not to contaminate the new container with any foreign material
or substances.

The product is manufactured with a shelf life of 24 months from the
date of manufacture.

When stored correctly and without the introduction of contaminants,
the opened or unopened product will remain effective until the expiry
date is reached, at which time the product should be discarded.

Applicator Usage and Care:

Adjust the size of the spray cone to suit your requirements. The
conical spray pattern should be wide enough to cover the whole wound
and the area immediately surrounding the wound.

The spray cone is able to be adjusted by twisting the spray nozzle
either clockwise (wider cone) or counterclockwise (narrower cone).

The spray nozzle supplied with the pack is robust and has been proven
to be able to apply at least the number of treatments in one or more
original containers.

If the product is being stored for a longer period, the spray nozzle
can be removed and cleaned using warm, soapy water and then flushed
with clean water.

Pump the nozzle empty of water and ensure it is thoroughly dry before
replacing it in the product.

Introducing water to the formulation during this process could lead to
breakdown of the product while in storage.

Safety

Do not ingest. Avoid contact with eyes and mouth.

For external use only. Do not use for any other purpose.

For animal treatment only.

Key Benefits:

The ingredients in GRO Wound Relief and Repair have been found clinically or through traditional means to provide the the following benefits.

Pain Relief

Reduced Bleeding

Wound and Tissue Healing

Anti-Inflammatory

Antiseptic

Burn Relief

Insect Repellent

Antihistamine

Increased Immune Response

Pack Size: 1 Litre

Download Product Label